Erasing the motor memory
Please note that these steps reset/delete all remote controls,
upper and lower limits as well as favourite position.
N.B. Only switch off the power for the motor to be reset.
– Set the blind between the upper and lower limit.
– Switch off the power supply for 2 seconds.
– Switch the power supply back on for 10 to 15 seconds.
– Switch off the power supply for another 2 seconds.
– Switch the power supply back on. The blind moves
for 5 seconds. If the blind is positioned at an end limit,
the movement will only be a jog.
– Hold down the programming button on the back of the
remote control until the blind jogs twice.
All the remote controls, upper and lower limits and favourite
position are now erased from the memory of the motor.
Troubleshooting
The motor does not work
Check:
– The wiring of the motor.
– The power supply specifications.
– The compatibility of the control.
– The heat generated (wait for the motor to cool
down – this can take up to 20 min).
The remote control does not work
The battery may need to be replaced.
Please contact your local sales team or customer
service on +45 8953 1866.
The equipment stops too soon
Check:
– The crown is properly fitted to the roll.
– The end-limits of the motor are properly adjusted.
The equipment is noisy
Check that:
– The wheel and the crown are well adapted to the tube.
– The mechanical plays between motor, accessories,
tube and end of roll are reduced as much as possible.
– The wheel is properly fixed to the tube.
– The equipment is not constrained in the cassette/between
the brackets.
– There is no debris in your tube.
– The power supply is within the specification.
– The temperature of the environment conforms with the
recommended operating temperature.
Environment
Damaged electrical products and batteries should not be
disposed of with normal household waste. They should be
dropped in specially provided containers or at an authorised
organisation that will ensure they are recycled.