Powering Operations for the 965X
2-12
965X Operation Manual
About Emergency Stops
Important:
Learn all safety precautionary controls on the machine.
Depending on the model of machine, there are emergency shutdown (E-
Stop) switches located at key points around the machine.
The E-Stop switches are to be used when the machine is out of control or
is about to damage personnel or equipment.
When an E-Stop switch is activated, high voltage power is cut to the
machine. The motors will stop, but power to the PLC and the Operator
Station Screen will remain on.
To Resume Normal Operation after an E-Stop
If an E-Stop is activated, use the following procedure to recover, after the cause of the emergency
stop is resolved:
1.
De-activate the E-Stop switch by pulling it out.
2.
Push the
Start Machine
button on the operator's station
3. Home
the Machine.
Other Safety Controls
If any of the safety controls below are activated follow the same steps to resume after an E-Stop is
activated.
Other safety controls may include:
•
Gate Latches:
Sensors are located on the gates surrounding the machine. If a gate is
opened the machine will shut down.
•
Laser Safety Scanners:
These are located on the front of the machine. These assem
-
blies create an invisible safety field stopping the machine if the operator enters the
cutting area of the machine.
•
Safety Curtain:
This creates an invisible curtain on all entrances to the machine.
About the Computer Setting
The
Computer
setting disables the machine but allows access to the
Operator’s interface.
Summary of Contents for 965X
Page 103: ......