About the Main Screen
2-35
KVAL 990-F4 Operation Manual
Screw Setup Controls
This Section contains buttons to load the
Hopper
.
•
Load the 6 Shooter Hopper
Press the button to start the
screw loading process. This action can also can be oper
-
ated at the 6-Shooter assembly.
•
Hopper Screw Type.
Select the Hopper to be used in the
process.
Note:
The button titles for Hopper at the
Calibration
screen. See
Lock Control Section
Control the lock parameters, in the
Lock Section
group. There are three settings to
choose
(Lock 1, Lock 2, and Lock 3)
. Lock location is displayed fore each defined lock
location.
The settings include:
• Yellow Enable/Disable button for
Lock
. Press button to toggle
all Lock setting ON or
OFF.
•
Lock Bore
: Press button to toggle the
Lock Bore
for Shallow Drill and On or OFF.
•
Bolt Drill
: Press button to toggle the
Bolt Drill
ON or OFF.
•
Face Plate Router
: Press button to toggle the
Face Plate Router
ON or OFF
•
(Option) Ball Catch
Drill: Press button to toggle the
Ball Catch
Drill
ON or OFF.
•
Lock
: Press button to toggle
all Lock setting ON or OFF.
•
(Option) Lock Backset:
Press to toggle
Backset
parameters.
•
Fast Lock Plate Timing
is the normal operating process (No Extend Time), Select to
toggle Fast Lock Timing On or Off.