About the Manual Screen
2-37
KVAL 990-F4 Operation Manual
Lock Jog
Manually control Lock Functions in this section.
•
Jog Left or Right:
Push and hold the
Left
or
Right
button
to move the Lock to the right or left (from the perspec
-
tive from the front of the machine.)
• Speed:
Adjust the seed of the movement of the lock
section. Select the white box and enter the percentage of
speed. This is a real time adjustment.
•
Lock:
Press if a new Chipout Block is installed on the
lock section To start the burn sequence. a new hole will
be slowly drilled. the process will automatically stop
when finished. See the
Service Manual
for information
on Chipout Replacement.
Width Adjust:
•
Open
:
Press and
hold
the
Open
button to open the
width adjust carriage. To stop the carriage, release the
button. The carriage will also stop if the positive travel
limit eye is activated.
•
Close:
Press and
hold
the
Close
button to close the
width adjust carriage. To stop the carriage, release the
button. The carriage will also stop if the negative
travel limit eye is activated.
Door:
•
Stop:
Press the
Stop
button to extend or retract the
door stop.
•
Clamp
:
Press
Clamp
to activate the cylinders that clamp the door.
Feed:
•
Reverse:
Press and hold the
Reverse
button reverse the feed of the door. To stop the
feed, release the button.
•
Forward:
Press and hold the
Forward
button to move the door feed forward. To stop
the feed, release the button.
•
Normal Speed:
Press to toggle between
Normal Speed
and
Slow Speed.
Force Narrow Door:
The
Force Narrow Door
button can be used to mimic the narrow door mode sensor. If
sensor is damaged, press this button to feed narrow doors into the machine.
Narrow Door Recovery:
If a narrow door gets stuck in a machine, push this button to lift and unclamp. Door can
then be moved manually out of the machine.
Table Jog
