About Calibration
KVAL 990-F4 Operation Manual
2-44
Lock Location Process
Run a known good lock cut at a standard location on a
Right Hand or Left Hand door.
Once the lock cut is completed, check the distance from
the top of the door to the center of the lock.
Note the measurement value and compare to specifica
-
tion
If the lock location is correct, there is no need to perform
this process, If it is not correct, follow the instructions
above.
Lock Location Adjustments
Adjusts the lock location in the back section. Adjustments can be made for right hand and
left hand doors for 6'8'', 7'0''and 8'0'' door sizes.
Lock Location:
1.
Select the size door (
6'8''-7'0''-8'0'')
2.
Select Right Hand or Left Hand depending on
the door run through process.
3.
Under Base, select the
Combine with Base
but
-
ton.
4.
Point of view: Front looking into the
machine.
Enter a positive number to move the
lock cut to the right Enter a negative number
to move the lock cut to the left.
5.
Re-run the lock cut.
6.
Measure again and repeat steps 3 to 4 until the
center of the lock is at the desired cut location.
7.
Once the completed with calibration, select the
Combine with Base
button to store the
data.
8.
Exit Main Calibration Screen.
Measure
