Operator’s Tour
2-6
KVAL 990-HB Operation / Service Manual
About the Hopper
Review to the figure below for identification of Hopper assemblies. See “Hopper Pro-
cess” on page 2-7 for operation descriptions.
Screw Track-
ing Plate
Assembly
Gate Assembly
Hopper
Quick Change Dump Gate
Quick Change
Dump Con-
tainer
Hopper Cylinder
Screw Delivery Tubes
Air Injected
Plate Assembly
Cylinder
Screw Pick
Off Slide
Assembly
Screw Pick-Off
Cylinder
FIGURE 2- 5.
Hopper Part Call-Outs
Important:
Do not adjust any of the Hopper air cylinders. They are adjusted at the
factory. Any adjustment may cause timing issues with the operation of
the Six Shooter. If you think problems are being caused by the cylinders,
please contact the KVAL Service Department for direction.
Important:
Do not put Magnetized Screws in Hopper. Magnetized
screws can cause sluggish response to screws getting
stuck. Hopper plates could get magnetized and will have
to be demagnetized with a degausser.
Summary of Contents for 990-HB
