Machine Feed Back
At the top and at the bottom right hand cor-
ner of all user screens is status feedback
information. The information generated is
as follows:’
1.
General Machine Status
2.
Front Section Status
3.
Back Section Status
4.
Current Servo Positions
Note:
Use this information to isolate issues if having
problems with the machine.
1
2
3
4
Description of User Interface Screens
2-23
KVAL 990-HB Operation / Service Manual
Controlling Access to User Screens
The 990-HB has the ability to lock out changes to certain parameters such a presets and calibra-
tions.
Note:
Locked out parameters may vary due to customer design wants.
To allow the operator to make changes to parameters, turn the
Set Up Lock
to the On position. When this key is in the Off position, the parameters are
locked out. No changes to the parameters may be made in the off position.
The key may be taken out in the off position, to prevent any inadvertent
changes to the cut parameters.
Note:
Set Up Lock
Summary of Contents for 990-HB
