Door Spec Group
Set the parameters for the door in the
Door Spec
group. The
settings include:
• Shows the preset setting that is running
• Can enter a door thickness.
• Choice between two door thickness settings.
• Can Select Hopper
• Full shift Mode moves all the six shooter heads to the
side to allow manual hinge application.
Hinge Spec Group
Set the parameters for the
hinges in the
Hinge Spec
group. The settings includes:
• Hinge Enabled/Disabled
toggle button.
• Router speed adjustment.
Adjustment is immediate.
• Screw Enabled/Disabled
toggle button.
• Hinge Calibration Enabled/Disabled toggle button.
• The choice of pre-drill patterns
You can select
Pre-Drill
buttons to down load pre-drill parameters or turn off this func-
tion. To set Pre-Drill parameters, see “About the Pre-Drill Screen” on page 2-32 .
Description of User Interface Screens
2-26
KVAL 990-HB Operation / Service Manual
Summary of Contents for 990-HB
