Backsection Group
Set the lock parameters,
in the
Backsection
group.
The settings include lock
specifications for 3 lock
settings, the ability to
enable and disable
lock
bore, bolt drill, and face plate routing.
Lock Backset
indicates the backset distance for the each downloaded preset.
Auto Enable and Disable Buttons
From these buttons you can toggle auto functions on or off.
Auto Feed:
Press
Auto Feed
to toggle the auto feed on or off. In auto
mode, the feed system will bring in and clamp a door, wait for processing
to complete, then feed the door to out.
Feed Through:
Press
Feed Through
to toggle the feed through on or off.
In feed through mode, the door will pass through the machine without
processing.
Auto Width:
Press
Auto Width
to toggle the auto width on or off. In auto width mode,
the machine will automatically set the width adjust system for optimum clamping.
Auto Unclamping:
Press
Auto Unclamping
to toggle auto Unclamping on or off. The
auto unclamp button sets the machine to automatically unclamp the door after machin-
ing is completed.
Clear Screws
The
Clear Screws
Button allows you to clear any stuck screws in the six
shooter heads.
Description of User Interface Screens
2-27
KVAL 990-HB Operation / Service Manual
Summary of Contents for 990-HB
