Operator’s Tour
2-7
KVAL 990-HB Operation / Service Manual
Hopper Process
1.
Pour Screws into the
Hopper.
Note:
The recommended maximum amount of screws a quantity of 600.
2.
The
Hopper
moves up and down periodically during the process by the
Hopper Cyl-
inders
to organize the screws and deliver them to the
Screw Tracking Plate
.
3.
The
Gate Assembly
monitors the quantity of screws delivered to the to the
Screw
Tracking Plate Assembly
.
4.
The screws are stacked
in the slots of the
Screw
Tracking Plate Assem-
bly
.
5.
The
Screw Pick Off Cyl-
inder
moves the
Slide
Assembly
to capture
screws six at a time.
6.
Press
Start Sequence
on the Six Shooter Control panel to activate the Slide Assem-
bly to drop the screws into the
Screw Delivery Tubes.
7.
Each tube has air injectors to speed the delivery to the
Screw Receiver Tubes
.
Quick Change Process
Some Six Shooter Systems have an a quick change option to quickly change to differ-
ent colored screws. To start the quick change process:
1.
Park the Six Shooter.
2.
Press the
Load/Unload
button on the Six Shooter panel.
The back section of the Hopper will cycle upward once to shift all the screws from
the back door to clear screws between the back door of the hopper and the slides.
3.
Once the Hopper is in the up position, the door will open and the Hopper will cycle
down quickly to throw the surplus of screws out the funnel container.
4.
Once in the back section is in the down position, the front section (
Screw Tracking
Assembly
) moves upward to drain the rest of the screws out of the hopper this will
cycle one more time to clear the screws from the slides.
5.
Press the
Reset
button on the Six Shooter panel located mid machine on the front
section.
6.
Fill the Hopper with new screws.
Summary of Contents for 990-HB
