Check Specifications of the Front Section
3-11
KVAL 990-HB Operation / Service Manual
2.
Check, measure, and calculate specifications of Router cut.
3.
To set a new reference, go to the calibration menu and select
Combine with Base.
4.
X:
If the Router cut position is to the right-
enter positive number. If cut position is to
the left -enter a negative number
Y:
If the Router cut position is high-enter
negative number. If cut position is low-enter
a positive number
Z:
If the Router cut depth is too deep enter
a negative number. If cut is shallow -enter a
positive number
Diameter:
The diameter menu allows
adjustment compensate for discrepancies
to the actual size of the router bit. If the
diameter is not correct, it will affect the X,Y
and Z parameters.
Enter calculations.
FIGURE 3- 8.
Router Calibration Menu
5.
Repeat until cut is centered.
6.
Select the
Combine with Base
button to finish.
-
Step 3: Counter Rotate Router Calibration
Verify the Counter Rotate Router
• The depth of the router should = 0.100'' deep.
• The length of the router should = 1.000'' plus the diameter of the bit.
• The width should = the diameter of the bit.
• The
slot should be centered in the H-block and center on the thickness of the door
Adjusting the X,Y,Z, and Diameter of the Counter Rotate Router
Follow the procedures to calibrate as described in the “General Instructions to Adjust
X, Y, and Z” section, except apply the calculations and inputs to the Counter Rotate
Router menu. Below is a summary of the calibration steps
Summary of Contents for 990-HB
