About the Six /Eight Shooter System
KVAL 994-X Operation/Service Manual
2-12
About the Six /Eight Shooter System
The Six and Eight Shooter systems simultaneously drives screws into the jamb and the door to
attach the hinges.This section describes the assemblies of the Six/Eight Shooter. Below is a gen-
eral description of how to use the Six/Eight Shooter.
1.
Screws are poured into the Hopper at the top of the machine, where they are auto-
matically sorted.
2.
Six/Eight screws are air injected though tubes to the screw gun at the bottom of the
six shooter.
3.
The Six/Eight Shooter is mounted on an overhead track that is precisely aligned to
ensure the hinge is properly position into the pocket at each hinge location.
4.
The operator:
a.places a hinge to the magnetic indexing fixture
b.rolls the Six/Eight Shooter over to the hinge location and pivots it into the
“H” block.
c.drives all six screws into the door and jamb.
d.press the 'Reset' switch then raises the Six/Eight Shooter and retracts screw
drivers out of the pocket
Major Part Identification
Hopper
Screw Delivery Hoses
Operator Controls
Magnetic Indexing Fixture.
Hinge is Placed Here
Drive Assembly:
• Air Motor
• Gearbox
• Six Screw Driver Bits
(
Eight bits for Eight Shooter)
FIGURE 2- 10.
Photo of Six Shooter on the 994-X
Summary of Contents for 994-X
