Kvaser Memorator Professional User’s Guide
23 (37)
CAN Channels
2 (CAN 2.0A and 2.0B active).
CAN Transceivers (HS)
SN 65251 (Compliant with ISO 11898-2)
CAN Transceivers (HS)
TJA1054 (Compliant with ISO 11898-3)
Microcontroller
Renesas M32C
CAN Bit Rate
5 kbit/s to 1 Mbit/s
Timestamp resolution
2
µ
s
Error Frame Detection
Yes, both channels.
Error Frame Generation
Yes, when used as a USB-CAN interface.
PC interface
USB 2.0.
Supports HiSpeed (HS) at 480 Mbit/s.
Compatible with USB 1.1 at 12 Mbit/s.
Power consumption
~5 V and 130 mA if powered from the USB and
~850 mW if powered from the CAN bus.
External power
Pin 9 (V+) and pin 3 (GND) on CAN channel 1.
Minimum operating voltage
6.2 V DC (cold start) and 5.6 V DC (during operation).
Maximum operating voltage
35 V DC.
Absolute maximum input voltage
48 V DC.
Software requirements
Windows XP or later. (For other operating systems,
see Kvaser web or contact Kvaser support.)
Hardware configuration
Done by software (Plug & Play).
Dimensions (W x L x H)
46 x 115 x 22 mm (1.8 x 4.5 x 0.9 inch)
Operating temperature
−40
◦
C to +85
◦
C
Weight
142 g including cables and connectors.
Storage temperature
−40
◦
C to +85
◦
C
Relative Humidity
0% to 85% (non-condensing.)
External trigger
Available on CAN connector 1 pin 4. The input is pro-
tected by a self-healing fuse and has a 1 k
Ω
pull-up to
+5 V. The firmware can detect both rising and falling
edges. The allowed voltage is 0 - 5 V DC.
External output
Available on CAN connector 2 pin 4. The output is a
pull-down to ground and is protected by a self-healing
fuse. The allowed voltage is 0 - 5 V DC.
Table 10: Kvaser Memorator Professional Technical specifications
5.3
Performance comparison
In Table 11 on Page 24 the performance of the Kvaser Memorator Professional is
compared with its older sibling, the Kvaser Memorator.
Kvaser AB, Mölndal, Sweden — www.kvaser.com