Kvaser Eagle User's Guide
13(30)
Kvaser AB, Mölndal, Sweden
— www.kvaser.com
Table 4: LED Indicators, Logger Mode
CAN status
CAN1/CAN2 emitting short flashes:
CAN messages are sent or received
CAN1/CAN2 blinking and ERR blinking red:
The CAN channel is
error passive
ERR emitting short yellow flashes:
Error frames are received on CAN1 or CAN2
Error conditions
ERR constant red with one yellow flash:
CAN overrun
ERR constant red with two yellow flashes:
Disk full
ERR constant red with three yellow flashes:
Configuration file missing or corrupt
ERR constant red with four yellow flashes:
Disk error
ERR constant red with five yellow flashes:
Some other major error; Contact support
Logging status
PWR 90% on and 10% off:
Everything OK; logging started without problems. The device is “armed” and waiting for
a trigger.
PWR flashing:
Everything OK, logging is active and actively logging traffic
PWR blinking slowly 50/50:
Logging has stopped due to a trigger condition and the Kvaser Eagle is off bus.
When connected to Kvaser Memorator Tools
“Running lights”:
Device is communicating with the application.
ERR blinking red:
Indicates disk activity such as formatting.
Other blink patterns
All LEDs blinking slowly:
Disk is missing or improperly inserted, and no USB communication is detected. Check
the disk or the USB connection.
PWR emits a flash every few seconds; the other LEDs are off:
No USB communication. Check USB cables and communication. Unplug the device and
reconnect it after a few seconds. Check that the device driver is installed correctly.
