Kvaser U100S-X2 User’s Guide
13 (24)
Figure 8: The TX LED bar lights up from the USB side to the CAN side of the unit,
while the RX LED bar lights up from the CAN side to the USB side of the unit.
at 50% bus load. Figure 9 on Page 13 shows two different bus load conditions.
The image on the left shows the unit transmitting and receiving data corresponding
to 50% bus load in each direction for a total of 100% bus load. The image on the
right shows the unit transmitting data corresponding to 100% bus load.
Figure 9: The yellow-lit area of the LED bars is proportional to the bus load. Both
images indicate a bus load of 100%.
3.9
The t programming language
The Kvaser t programming language is event oriented and modelled after C. It can
be used to customize the behavior of the Kvaser U100S-X2 and other Kvaser t
capable devices.
Kvaser AB, Mölndal, Sweden — www.kvaser.com
