Using the ADCU Interface
54-0147
89
Return to "Manually Controlling the
Antenna"
Sat frequency Scan?
Yes
Next
Return
Symbol Rate: XXXXX
-
Enter
+
Set FEC Code: X/X
-
Enter
+
Scan frequencies
Please Wait
Update frequency?
YES
NO
Updating frequency
Please wait
Restart antenna?
YES
NO
Use the -/+ keys to select each
number. Selecting ENTER will cycle
through each digit and then launch
the FEC code screen.
(Valid settings are 01000-39999.)
Use the -/+ keys to scroll through
the available FEC codes:
1/2 - 2/3 - 3/4 - 5/6 - 6/7 - 7/8.
Use the ENTER key to accept your
selection.
Restart
Antenna
System
No strong frequency
Exit
If no strong satellite signal is found
at the selected frequency, the
screen will display:
Exit returns you to the "Sat
Frequency Scan" screen.
Try the
process again, but using a different
symbol rate or FEC code.
This scan may take up to
10 minutes to complete.
Figure 3-35
Satellite Frequency Scan
To find a valid symbol rate and FEC
code, refer to an up-to-date satellite
table either in a magazine or on the
Internet. For your convenience, this
data is available (for the system’s
predefined satellites) on our web
site at
The vessel must remain stationary
during this process.
Summary of Contents for KVHTRACVISION G4
Page 136: ......
