EN
Instruction Manual
Hydropneumatic tool for rivet nuts from M3 to M10
with stroke and pressure adjustment
FASTSETM10
www.kvt-fastening.ch
36
7 -
SERVICING THE TOOL
7.1 -
MAINTENANCE STATUS
Maintenance operations must be carried out with the tool stopped and disconnected from the pneumatic supply line.
Warnings:
•
The tool maintenance instructions must be followed carefully.
•
To ensure safety and perfect tool efficiency, you are recommended to use exclusively ORIGINAL spare parts.
7.2 -
CLEANING
It is a good rule to completely clean and grease the tool on a periodic basis (depending on the type and frequency of use).
Anyhow these operations must be carried out at least once a year.
P 3
Shut-off all sources of power to the tool.
The operator must wear and use suitable personal protections before starting to clean the tool
7.3 -
ORDINARY MAINTENANCE
See Figure 6.2 - A.
In order to prevent stoppages and faults of the tool, an ordinary maintenance (including inspections, checks and
operations) must be scheduled to keep the following under systematic control:
•
state of lubrication of the tool.
•
state of wear of consumables.
