Stand: 19.03.12
Seite 12
KW Hydraulik GmbH
Tel.:
03675/42198-0
Köppelsdorfer Str. 132
Fax:
03675/42198-11
D-96515 Sonneberg
e-mail:
info@kw-hydraulik.de
Germany
Internet: www.kw-hydraulik.de
SSBZ
SSBZ
SSBZ
SSBZ
Either you can read the bending-angle at the scale of the working-table or adjust it at the
optoelectronic sensor (picture 9). You have to use an electronic hydraulic pump with a
stop-electronic (SSBZ-adjustment) for using the optoelectronic sensor as an angle-
disconnect.
You have to adjust the wanted bending-angle at the optoelectronic sensor (picture 9). But
you have to take care that the angle-mark (white scale: 0º, 30º, 45º, 60º, 90º) is adjusted to
the right strength of the material (red scale: 5, 8, 10, 12 mm).
picture 9: optoelectronic sensor
Indication! The different worthies of the materials could cause a small deviation of the
adjusted and the reached bending-angle. In these cases you have to find out the best
setting of the button by testing. For preventing an over-bending of the rail we advise that
you go slow to the wanted angle.
By bending without optoelectronic sensor you have to take the suitable angle-settings from
the working-table. For this you can take all hydraulic pumps with a maximum pressure of
700 bar.