Stand: 19.03.12
Seite 14
KW Hydraulik GmbH
Tel.:
03675/42198-0
Köppelsdorfer Str. 132
Fax:
03675/42198-11
D-96515 Sonneberg
e-mail:
info@kw-hydraulik.de
Germany
Internet: www.kw-hydraulik.de
SSBZ
SSBZ
SSBZ
SSBZ
Attention! The contact rail waves in the direction to the bending-punch during all bending-
processes. There must not be any person or item in the distance of the wave.
5.2
punching tool
punching tool 1
The punching tool 1 is used for punches and long-punches in contact rails of aluminium
and copper. The maximum strength of the material is 12 mm.
The punching tool 1 consist of hole-punch and die-reception. The punch-insert consist of a
die and a hole-punch (picture 12). The hole-punch (picture 13) is equipped with a centring-
spike which allows a faster and exact positioning.
picture 12: punching tool 1
* belongs to the punch-insertion
For insertion the hole-punch the latch (rubber feather) has to be taken away from the hole-
punch reception. For the re-latching, the female-screw has to be turned with the milled
side in direction to the cylinder. You can take the latch away; you can install the punch and
tie it up with the hexagon-screw. After that you have to pull the latch over the hole-punch
reception and to tie it up with the female-screw.
die*
hole-punch reception
female-screw
stopping-bolt
not
latch
hexagon-
screw
die-reception