Stand: 19.03.12
Seite 18
KW Hydraulik GmbH
Tel.:
03675/42198-0
Köppelsdorfer Str. 132
Fax:
03675/42198-11
D-96515 Sonneberg
e-mail:
info@kw-hydraulik.de
Germany
Internet: www.kw-hydraulik.de
SSBZ
SSBZ
SSBZ
SSBZ
picture 16: cutting tool
At first make the contact rail machining centre SSBZ, according to capture 4, ready for the
work.
For cutting please adjust the SSBZ as followed:
Before the insertion of the tool you have to remove the plate at the basic device
(small way between the plates, see picture 7).
For montage of the tool at first you have to insert the blade (picture 16) into the
counter blade. The labels of the two parts “above” have to agree.
Then put both blades together from above into the guide (picture 1).
After that please push the blade on the piston-bar until the latch-bolt is locked.
Attention! Pull the latch-bolt!
Lay the contact rail in and adjust the working-group with the hand-wheel that the
counter blade cuts in a middling position to the contact rail (worth at the height-
scale = ½ x height of rail, like in picture 3). The height-scale shows the distance
between working-plate and piston-middle-axle (picture 1).
For using the our electronic hydraulic pump with a stop-electronic you have to take
care that the optoelectronic sensor (picture 9) is in the 0-position, i. e. that the to the
tool showing front side of the button is flush with the fix-appliance (picture 17).
counter
blade
not
latch-bolt
cutting
blade