Stand: 19.03.12
Seite 20
KW Hydraulik GmbH
Tel.:
03675/42198-0
Köppelsdorfer Str. 132
Fax:
03675/42198-11
D-96515 Sonneberg
e-mail:
info@kw-hydraulik.de
Germany
Internet: www.kw-hydraulik.de
SSBZ
SSBZ
SSBZ
SSBZ
5.4
offsetting tool
The offsetting tool is used for offset contact rails of aluminium and copper up to 120 x 12
mm (picture 18).
picture 18: offsetting tool
At first make the contact rail machining centre SSBZ, according to capture 4, ready for the
work.
For offsetting please adjust the SSBZ as followed:
Before you put the tool in you have to remove the lay on of the basic-device.
For the wanted pawning you have to look in the schedule for the right copulation of
the plates.
Copulation of plates / pawning
10.0 mm
8.0 mm
6.0 mm
5.0 mm
12.00
10.00
x
8.00
x
x
6.00
x
x
5.00
x
x
At the insertion of the plates to the offsetting-cheeks you have to take care that for a
montage of more than one plate at each offsetting-cheek the plate has to be at the
outside with the label 10.0. This means it has to show in the direction of the rail.
Put the movable cheek of the offsetting tool with the below not on the guide rail of
the basic device and move the piston-bar out until the latch-bolt is locked.
Attention! Pull the latch-bolt!
fixed offsetting-
cheek
latch-bolt
support-plates
movable
offsetting-cheek