Stand: 19.03.12
Seite 3
KW Hydraulik GmbH
Tel.:
03675/42198-0
Köppelsdorfer Str. 132
Fax:
03675/42198-11
D-96515 Sonneberg
e-mail:
info@kw-hydraulik.de
Germany
Internet: www.kw-hydraulik.de
SSBZ
SSBZ
SSBZ
SSBZ
2
Directions of safety
danger area / handling
It has to be that the hydraulic-pump can be activated only from the user of the
machining centre.
It is only allowed that one person is in the danger zone of the machine.
Especially pay your attention to the contact rails. They swing in the direction of the
piston during the bending process. In this area there must not be neither persons
nor items.
Do not touch into the danger zone of the tools during the working-process.
During the placing of the punch on the piston there must not be fingers between the
punch and the die during the forward-moving of the punch (see in capture 5).
Never bow over the tool between a working-process.
insertion
It is only allowed to use the contact rail machining centre and its tools for its
working-aims.
It is only allowed to work with the tools from KW at the SSBZ.
The pressure-hose has to be for a working pressure of 700 bar and it must not be
damaged or wear out.
It is not allowed to install pumps with a pressure of more than 700 bar.
It is only allowed to install pumps with a maximum output-work of 1.5 l/min.
Hydraulic pumps have to be equipped with a coupling and an SSBZ-adjustment for
optoelectronic sensor.
It is only allowed to connect the hydraulic system under a pressure-free condition.
Please take care of a perfect condition of the tools.
The appliance has to stand on a firm and straight ground.
Put the dust protecting caps into each other during the working-process.
Protect and store the contact rail machining centre that it is protected against
misuse.
Do never cut steel. The blade does not take this load.