Stand: 19.03.12
Seite 8
KW Hydraulik GmbH
Tel.:
03675/42198-0
Köppelsdorfer Str. 132
Fax:
03675/42198-11
D-96515 Sonneberg
e-mail:
info@kw-hydraulik.de
Germany
Internet: www.kw-hydraulik.de
SSBZ
SSBZ
SSBZ
SSBZ
4.3
settings of the height
The SSBZ is equipped with a hydraulic height-setting. By turning of the hand-wheel the
distance can be adjusted from the working-plate to the piston-axle. Adjust the height
during the cutting and bending always that the middle-axe of the piston is in agreement
with the tool (picture 3). You can read the adjusted worth (worth at the height-scale = ½ x
height of the rail) at the height-scale (picture 1).
picture 3: adjusting the height of the working-device
Indication! Adjust the wanted height always by turning the hand-wheel in the clock’s
direction. Otherwise the showed worth could change during the operation by itself.
4.4
operating of the survey-bar
The survey-bar (picture 4) is used for punching with priority. You can adjust it by opening
of the two fixes. The adjusted measure refers always to the piston-axle. This means,
during the punching it refers to the centre of the punch. You can read the worth at the
outside of the fix-handle. (see arrow in picture 4).
Should the survey-bar-angle for a special using be in a difficult position you can adjust it
after untie the front sided hexagon-screw easily.
material
cutting tool
piston middle-axle
moving direction of the working device