U P
KEEP
PARALLEL
3. Install Exterior Assembly.
Bolt
3
Wire
Harness
Adapter
For 2-1/8”
diameter only.
Fig. 9
Fig. 8
Fig. 7
a.
Place adapter on door as shown,
(note, adapter is not required if
mounting on a 1-1/2” (38mm)
diameter hole.
Crank
Torque
Blade
c.
Place assembly on door, threading
the wire harness (through adapter - if
used) and under the latch.
b.
Insert cylinder into exterior
assembly. With key in cylinder,
rotate the torque blade to align
with crank in latch.
a.
Carefully angle the connector of the wire harness - through the center
hole of the mounting plate, utilizing the notch hole to allow connector to pass
through (see figure 7).
e.
Check the vertical alignment for mounting
plate
and
exterior assembly. (See figure 9.)
h.
Repeat as required.
f.
Test. Using the key, retract and extend the
bolt a few times to test for smooth action.
c.
Slide wires through the notch until mounting
plate sits flush against door.
4. Install Interior Mounting plate.
Mounting
Plate
b. Important,
once the connector has passed through the center hole, tuck
the wire harness out of the way by pressing it into the notch hole as shown
in figure 8.
Notch
Hole
d.
Making sure that
exterior assembly and
cylinder
are pressed flush against exterior
door, insert mounting bolts and tighten.
g.
If action feels rough, loosen screws and
re-align the mounting plate and the exterior
assembly. Note: Also see step 1-c for possible
crank interference.
