23
SECTION: 14
BEAD ROLLER ASSEMBLY
The BEAD ROLLER is used to give the back section of the gutter some form and structure. The amount of pressure
will also control up & downhill on the back of the gutter.
FACTORY SETTING
: VERTICAL height of bead roller is 3/8” down from the top of the back of the gutter;
HORIZONTAL position is a 1/32” gap between the material being formed and the back-side of the top exit roller.
1.
BEAD ROLLER ADJUSTMENT:
a.
Loosen BOLTS A (2 places) to align bead roller assembly, and retighten after alignment is made.
b.
TO INCREASE OR DECREASE PRESSURE
to bead itself, loosen LOCKING NUT C and LOCKING BOLT B,
and turn eccentric shaft using a 3/16 Allen wrench in the adjustment hole to desired spacing.
c.
Adding too much pressure to the bead will cause the back of the gutter to run uphill. If this happens, simply relieve
pressure from bead and retighten LOCKING BOLT and LOCKING NUT.
2.
COMBO MACHINE ADJUSTMENT FOR 5” or 6” BEAD ROLLER
a.
Empty machine of coil prior to altering bead roller position
b.
Loosen LOCKING BOLT A (2 places), move bead roller assembly to desired location.
c.
Tighten LOCKING BOLT A (2 places).