42
SECTION: 24
6” to 5” COMBO CHANGE OVER CHECKLIST
1.
___ UNPLUG MACHINE:
Eliminate electrical power source.
2.
___ REMOVE COVERS:
Remove covers containing quick-release fasteners.
3.
___ REMOVE GUILLOTINE:
Remove 6” guillotine from machine.
4.
___ REMOVE BACK BELL ROLLER:
Remove from 6” position, and set it to the side.
5.
___ FLIP TOP #3 EXIT DRIVE ROLLER:
Remove & reinstall top #3 back drive roller in 5” position.
Turn roller end-for-end and reinstall using same 82-degree cap screws.
6.
___ INSTALL BACK BELL WHEEL:
Install back bell wheel in the 5” position.
7.
___ MOVE BEAD ROLLER ASSEMBLY:
Loosen and slide bead roller assembly into 5” position
8.
___ INSTALL 5” GUILLOTINE:
Install 5” guillotine on machine.
9.
___ SECURE 6” GUILLOTINE:
Place the 6” guillotine back into storage position.
10.
___ MOVE SKATE ROLLERS:
Pull retractable pins on skate rollers and move inward to 5” position.
11.
___ MOVE BACK GUIDE ROD:
Loosen guide rod bolts, and slide guide rod inward to 5” position.
12.
___ MOVE ENTRANCE GUIDES:
Loosen cap screw on both entrance guides, and move inward to stop at 5” position.
13.
___ MOVE FACE BOX ROLLERS:
Pull retractable pins and lower face box roller to 5” position.
14.
___ REMOVE 6” INSIDE ROLLER BAR FROM LIP BOX:
Remove red colored screws, remove roller bar and set to the side.
15.
___ INSTALL 5” INSIDE ROLLER BAR ASSEMBLY.
Remove 5” roller bar from storage position and install in lip box.
16.
___ STORE 6” INSIDE ROLLER BAR:
Secure 6” inside roller bar in storage position.
17.
___ MOVE LIP BOX BOTTOM ROLLERS:
Pull retractable pins and raise bottom half of the outside lip box roller to 5” position.
18.
___ MOVE COMPLETE LIP BOX:
Loosen mounting bolts and move lip box down and in to the 5” position.
19.
___ REINSTALL COVERS:
Refasten covers and lids to machine.
20.
___ MOVE COIL SPOOL HALVES:
Position spool halves for 11-3/4” or 12” coil.
21.
___ MOVE UPRIGHT ASSEMBLY:
Move upright assembly to the 5” position.
