6
SECTION: 4A
6” GUTTER MACHINE ORIENTATION
For communication purposes in the manual, the machine orientation is as follows: (SEE PG. 6)
A.
ENTRANCE
The ENTRANCE is where the forming process begins and where the material is fed.
B.
EXIT
The EXIT is where the forming process is complete and where the finished gutter exits the machine.
C.
RIGHT SIDE
The RIGHT SIDE of the machine is determined by facing the entrance end of machine.
The RIGHT SIDE of the machine is where the O.G or face side of gutter is formed.
COMPONENTS ON RIGHT SIDE:
1.
O.G. FACE GUIDE SHOE (RIGHT SHOE)
2.
O.G. FACE GUIDE BAR ASSEMBLY
3.
O.G. FACE FORMING BOX ASSEMBLY
4.
O.G. FACE LIP FORMING BOX ASSEMBLY
5.
O.G. FACE BELL ROLLER
D.
LEFT SIDE
The LEFT SIDE of the machine is determined by facing the entrance end of machine.
The LEFT SIDE of the machine is where the back of the gutter is formed.
COMPONENTS ON LEFT SIDE:
6.
BACK GUIDE SHOE (LEFT SHOE)
7.
BACK GUIDE BAR ASSEMBLY
8.
MOTOR AND GEAR BOX
9.
EXIT BACK BELL ROLLER
10.
BEAD ROLLER ASSEMBLY
E.
CENTER of MACHINE
The CENTER of the machine forms bottom section of gutter- drive assembly.
COMPONENTS IN CENTER OF MACHINE:
11.
#1 SKATE ASSEMBLY
12.
#1 DRIVE ASSEMBLY
11A. #1A SKATE ASSEMBLY
12A. #1A DRIVE ASSEMBLY
13.
#2 SKATE ASSEMBLY
14.
#2 DRIVE ASSEMBLY
15.
#3 SKATE ASSEMBLY
16.
#3 TOP & BOTTOM DRIVE FORMING STATION
17.
GUILLOTINE ASSEMBLY
NOTES:
_______________________________________________________________________________________
_______________________________________________________________________________________
_______________________________________________________________________________________
_______________________________________________________________________________________
_______________________________________________________________________________________
_______________________________________________________________________________________
