Chapter 6 - SAT Measuring Range
39
106 V3.2
Drive:
This allows the motor to be turned to the east and west.
Figure 6-14 DiSEqC 1.2, menu drive
After the menu is opened, the menu item STOP (motor is stopped) is activated. While you press
the left arrow key, the rotor moves in the easterly direction and stops immediately after releasing
the key. The same does the right arrow key in the westerly direction.
East limit:
This enables an eastern limit to be set for the rotating system that it cannot pass. To do so,
proceed as follows: First use the DRIVE function to move the motor to the position to be set as the
eastern limit. If you select the menu item
Limit East
, the eastern limit will be stored in the rotating
system.
West limit:
This enables a western limit to be set for the rotating system that it cannot pass. To do so, proceed
as follows: First use the DRIVE function to move the motor to the position to be set as the western
limit. If you select the menu item
Limit West
, the western limit will be stored in the rotating system.
Limits off:
This function allows you to override the eastern and western limits of the rotating system. The
motor can then travel to its mechanical limits again. If you select the menu item
Limits off
, the
limits in the rotating system will be deleted.
Save:
This function allows you to save in one of the 100 position memory locations a position to which
you have previously moved. The numbering of the memory locations goes from 0-99.
Position 0 is reserved for reference position 0 degrees. If you select the menu item
Save
, the following entry field is displayed:
You can use the numeric keypad to enter a memory location between 0 and 99. If you press the
ENTER
key, the current rotor position is stored in the pertinent memory location of the rotating
system electronics.
