Chapter 16 - SCAN Support for Finding Satellites 119
106 V3.2
Figure 16-2 SAT SCAN satellite found
The scan parameter (satellite, transponder frequency etc.) are a fixated component of the satellite
list. Therefore the SAT list should be kept up-to-date. (View chapter 16.5 - Importing a SAT list).
Note:
If Quattro LNBs are used, the various SAT identifications are not sent on all
levels. The LNB should be connected to the connectors for the horizontal high
or vertical low levels since only these levels are searched. The relevant data
can be found in the document which accompanies the SAT list.
16.2
SAT list
Open the SAT list by pressing
MODE ->
Satlist -> SAT List
if device is in default state. Use the ←
and → keys to browse through the list pages. Individual satellites can be selected using the ↑ and
↓ keys. Pressing the
ENTER
button displays the transponder list for the selected satellite.
Figure 16-3 SAT list
The SAT list is provided by the instrument manufacturer and updated on a regular basis. Check
whether the list being used is up-to-date (use the date code in the second line of the list for this).
For updating the list refer chapter 16.5 -Importing a SAT list.
