8
Figure 9 Connection of 100Base-FX Ethernet Port
The device uses laser to transmit signals in fibers. The radiation has
not been evaluated. The laser meets the requirements of level 1 laser
products. Routine operation is not harmful to your eyes, but do not look
directly at the fiber port when the device is powered on.
Caution:
4.3 100Base-X SFP Slot
Kyland Opal5/Opal8 IM-EN-June 2016
4.2 100Base-FX Ethernet Port
100Base-FX Ethernet port is equipped with ST/SC connector, and each port
consists of TX (transmit) port and RX (receive) port. To enable data transmis-
sion between Device A and Device B, connect the TX port of Device A to the
RX port of Device B, and the RX port of Device A to the TX port of Device B.
The following figure shows the wiring sequence of the 100Base-FX Ethernet
port. (The following uses an SC port as an example. The wiring sequence of an
ST port is the same with that of the SC port.)
TX
RX
TX
RX
TX
RX
100Base-X SFP slot: You can enable data transmission only after inserting an
SFP optical module into the slot and connecting cable properly.The
switch,which name contains “SMSFP” or “MMSFP”,is equipped with the SFP
optical modules in the following table.
Table 4 SFP Optical Modules for 100Base-X SFP slot
