66
FEATURES & CONTROLS
HOOD
You can open the hood on your UXV500iG to perform maintenance-
related tasks.
To open the hood, unhook the two rubber hood latches
1
and re-
lease the six plastic fasteners
2
. Press the center of the plastic
fastener to release it and pull if from the hood and the fender. Lift on
the back of the hood to raise it (it is hinged in the front).
2
2
2
2
2
1
1
1
1
1
To close the hood, carefully lower
it back into place on the chassis.
Hook the rubber hood latches
3
.
Reset the plastic fasteners
4
and insert them back into the
holes in the hood, the dash, and
the fender extensions. Set the
fastener by pressing the center
pin down so it is flush with the
fastener’s button head.
4
4
4
4
4
3
3
3
3
3
SWITCHES
Ignition Switch
The UXV500iG ignition switch is a three-position, key-operated
switch, The key can be removed from the switch when it is in the
OFF position.
OFF:
Engine is off. All electrical circuits
are off (except accessory circuit).
ON:
The engine can run as the igni-
tion is powered. The electrical cir-
cuits are on.
Allow thirty seconds between starting attempts to allow
the starting motor to cool. Continuous starting attempts
will result in overheating and damage to the starting motor.
START:
The starter motor is engaged by turning and holding the switch
in this position. Once released, the switch will return to the ON
position.
Summary of Contents for UXV500iG
