5
Fixed-speed cruising mode: Double-click the throttle after desired speed
has been reached (the cruising mode can be entered after the speed is
above 10 km/h), then release the throttle. Exit by pressing any button.
3) Power Button: Press and hold to turn ON, press again to turn OFF.
4) Speed button regulates the top speed (Low, Med, High, H+). Use on Low or
Medium when learning to ride the skateboard. High can reach speeds of 35 km/
h (22 mph).
5) Flashlight: press the LED button when the remote control is turned on, then
the remote control can be used as a flashlight. Always use the flashlight when
riding at night.
6) Forward/Backward switch: Push Forward (F) or Backward (B). Remote
makes a “beeping” sound when switching.
7) Remote control charging port: Insert the charging cable Micro/USB
connector of the remote control into the charging port of the remote control;
connect the other end to a 5V power supply (common for cell phones). When
the remote control has been fully charged, the power indicator of the remote
control is full, which means the charging is completed and the charger can be
unplugged.
Instructions for programming remote control code
The code program of each board and the supporting remote control is set when
the product leaves the factory, so users do not need to code again. However, if
you accidentally lose the remote control and need to replace it, the code must
be completed before use:
i.
First turn on the power of the board.
ii.
Long press the power button of the board for about 5-8 seconds and release
the button after the power indicator of the skateboard starts to flash.
iii.
Turn on the power of the remote control.
iv.
Use a paper clip to click on the remote control’s code key (small hole on
the bottom of remote); at this time, the power indicators of the board and
the remote control shall flash at the same frequency.
v.
Repress power buttons to turn on the skateboard and the remote control,
and then it can be operated normally.
