CHAPTER 2 NAMES OF PARTS
2-2
1
Original cover
<optional>
(Open/close to set the original on the platen.)
2
Operation panel
(Contains the keys and indicators for operating the copier.)
3
Left cover handle
(Hold to open the left cover.)
4
Left cover
(Open when a paper misfeed occurs.)
5
Multi-Bypass
(Load paper here when copying onto small-size or special
paper.)
6
Insert guides
(Be sure to set the paper width when loading paper on the
multi-bypass.)
7
Support tray
(Operate to use large-size paper.)
8
Toner cartridge
9
Toner cartridge release lever
(Operate to replace the toner cartridge.)
0
Waste toner tank
!
Waste toner tank release lever
(Operate to replace the waste toner tank.)
@
Cleaning shaft
(Pull and push back in after toner cartridge replacement or
when copy images become soiled with toner.)
#
Front cover
(Open to replace the toner cartridge or waste toner tank.)
$
Main switch
(Turn ON (|) before starting to make copies.)
%
Copy store section
(Copied paper is stored here.)
^
Ejection section
&
Platen
(Set originals here for copying. Place originals face-down
with the edges aligned with the size scales on the left and
rear sides of the platen.)
*
Original size scales
(Be sure to align the original with these when setting the
original on the platen.)
(
Drawer 1
(Holds up to 250 sheets of standard paper [standard paper
specified by our company].)
)
Drawer 2
(Holds up to 250 sheets of standard paper [standard paper
specified by our company].)
⁄
Drawer left cover
(Open when a paper misfeed occurs inside the drawer left
cover.)
¤
Length adjustment plate
(Adjust to the length of the paper to be set in the drawer.)
‹
Width adjustment lever
(Hold the lever and adjust the width guide to the width of
the paper to be set in the drawer.)
›
Drawer bottom plate
(Push down when loading paper.)
fi
Handles for transport
(The right two handles are indented handles. The left two
become handles when pulled out.)
Summary of Contents for KM-2030
Page 10: ...2 1 CHAPTER 2 NAMES OF PARTS 1 Main body...
Page 70: ......
