CHAPTER 6 CONVENIENT FUNCTIONS
6-4
(Inch)
(Metric)
3
2
4
1
(Inch)
(Metric)
2
1
(Metric)
(Inch)
2. Repeat Copy Function
This machine stores image data in memory and then performs
copying.
The repeat copy function allows the image data in memory to be used
for repeated copying. The copy contrast and the magnification ratio
can be changed for repeat copy.
Stored image data remains until the original image of the next job is
stored or the auto clear function is activated. The image data in
memory, however, can be deleted.
NOTE
• The repeat copy function can be disabled or limited by changing the
setting of “
&
Per rep copy [Permit repeat]” of the default
setting.(Page 7-6)
• Although the copy settings can be changed for a repeat copy, “Mirror”,
“Sort/group”, and “Default setting” cannot be changed.
• If the magnification ratio in repeat copying is decreased from the first
copying, memory may be insufficient.
• If the magnification ratio in the first copying is 99.9% or less, the ratio
in repeat copying cannot be increased from the ratio in the first copying
by more than 10%.
(1) How to make a repeat copy
After a copy run is complete, the message “Repeat Copy ...
Repeat Key” will appear.
Press the Repeat Copy key. The Repeat Copy indicator will
light up and the message “Repeat copy OK.” will appear.
When a prompt for repeat copy code appears, enter the
repeat copy code using the numeric keys. (The default
setting is 4850.)
Change copy settings as needed.
Press the Start key.
Copying will start.
(2) Repeat copy after sort/group
To change the number of copies after sort or group copying, select
“Additional copy”. To copy onto the same size paper with the AMS
function, select “AMS mode for all originals”.
NOTE
• If “AMS mode for all originals” is selected, the settings that can be
changed are paper source, paper length, paper material, and number
of copies.
• It’s impossible to select “AMS mode for all originals” in the repeat
copy after a scan/copy operation exceeding 60 pages.
After a copy run is complete, the message “Repeat Copy ...
Repeat Key” will appear.
Press the Repeat Copy key. The Repeat Copy indicator will
light up and the message “Repeat copy OK.” will appear.
When a prompt for repeat copy code appears, enter the
repeat copy code using the numeric keys. (The default
setting is 4850.)
Summary of Contents for 4850w
