KYOCERA Corporation
SERIES 6208 INSTRUCTION MANUAL
No.:205-03-108
106-03-004
PAGE 4/8
4. FPC/FFC 装着作業手順
Procedure for inserting FPC/FFC
挿入 Insertion
作業手順
Step
作業方法
Description
(1)スライダーを
開ける。
Open the slider.
スライダーを図のように引き上げて下さい。
一定の高さ(約 1.5mm)までしか上がりませんので硬くなったら、それ以上無理な力を
加えないように注意して下さい。
(注) トレー梱包の場合 スライダーは開放状態で納入されます。
エンボス梱包の場合 スライダーはロック状態で納入されます。
Pull up the slider in the direction shown by the arrow in the above figure. It moves up to
1.5mm approximately, and do not apply further stress once feeling a tug.
Note) The sliders are factory-opened for connectors packaged on trays, and they are
factory-closed and locked for connectors packaged in Tape & Reel..
(2)FPC/FFC を
装着する。
Insert the FPC/FFC.
図のように FPC/FFC をインシュレータの底に突き当たるまでしっかり挿入して下さい。
Insert the FPC/FFC until its end hits the bottom of the hole in the insulator housing.
スライダー
Slider