KYOCERA Corporation
SERIES 7129 INSTRUCTION MANUAL
No.:205-03-305
106-03-004
PAGE 7/12
(6)
手付けはんだの際には、テール部及び基板へのフラックス塗布はしないで下さい。コネクタ内部、接触部への
フラックス上がり、飛散の原因となり、接触不良等の不具合が発生する場合が
あります。又、はんだこてで端子に負荷をかけてはんだ付けを行うと、テール部変形、及び、インシュレータ溶
け等の恐れがありますので、ご注意をお願い致します。
Please do not apply flux onto the tail and PC board
,
when it is soldered manually
.
Splattered or migrated
flux inside the connector or to the contact points may cause imperfect contact
.
Also avoid giving any stress to the product with the soldering iron
.
It could deform tail or melt insulator
.
(8)
実装後、酸化の影響ではんだ付け部に変色が見られる事がありますが、製品性能に影響はありません。
There is no influence in the product performance thought discoloration might be seen in the soldering tail
after mounting.
(9)
実装後、テール上面にはんだ濡れ広がりのない場合がありますが、製品性能に影響はありません。
There is no influence in the product performance though the tail surface doesn't get wet with solder after
mounting.
(7) PLUG 側は接点が外側に露出している為、実装の際はフラックスの飛散にご注意願います。
In the mounting process
,
special care is needed so that the exposed contact points on the plug
side will be free from splattered flux
.
接 触 部
Contact area
はんだこて
soldering iron