Finishing
5-6
KX Driver
Using Hole Punch
1
In your application, open the
dialog box, then open
Properties
. (Select
from the
File
menu, and select
Properties
.)
1
2
In the
Basic
tab, under
Destination
, select a face-up or face-down finishing tray.
2
3
Click the
Finishing
tab, then select
Punch
.
3
4
Select the number of hole punches: 2 hole, 3 hole, or 4 hole. Available punch options
are set in the
Device Settings
tab and depend on the punch unit being installed on
the device and selected. For further details, refer to
Installing Optional Devices
on
page 2-1. For information on positioning the hole punches, refer to
Position the Hole
Punch
below.
4
•
For metric specification, use 2 hole and 4 hole punch options.
•
For inches specification, use 2 hole and 3 hole punch options.
5
Click
OK
to return to the
dialog box.
5
6
Click
OK
to start printing.
6
The print job will be punched by the finishing device and delivered to the output tray.
For further details about hole punch specifications, refer to your finishing device’s
Operation Guide
.
Position the Hole Punch
Note:
Some models do not support the punch position option.
