![background image](http://html1.mh-extra.com/html/kyocera/ecosys-m6526cdn/ecosys-m6526cdn_operation-manual_2015445140.webp)
Setup and Registration
6-13
6
Retry Times
The number of retry times can be changed automatically.
NOTE:
Retry times can be set to between 0 and 14.
For Redial, refer to
Dialing the Same Receiving System (Redial) on page 3-29
.
1
Refer to
Basic Operation Procedure on page 6-7
.
2
Press the
or
key to select [Retry Times].
3
Press the
OK
key.
4
Use the numeric keys to enter the number of retry
times.
5
Press the
OK
key.
ECM TX
ECM is a communication mode specified by the ITU-T (International Telecommunication Union) that retransmits
data when an error occurs. Fax machines that have ECM mode check for errors as they communicate,
preventing distortion of the image due to noise on the line and other conditions.
NOTE:
When there is a large amount of noise on the line, communication may take slightly longer than when
[Off] is selected.
1
Refer to
Basic Operation Procedure on page 6-7
.
2
Press the
or
key to select [ECM TX].
3
Press the
OK
key.
4
Press the
or
key to select [On] or [Off].
5
Press the
OK
key.
TX Start Speed
When communication conditions are bad, the fax may not be transmitted correctly. In that case, set a lower TX
Start Speed.
Normally this should be used with the default setting.
1
Refer to
Basic Operation Procedure on page 6-7
.
2
Press the
or
key to select [TX Start Speed].
3
Press the
OK
key.
4
Press the
or
key to select [9600bps],
[14400bps] or [33600bps].
5
Press the
OK
key.
Summary of Contents for Ecosys M6526cdn
