1. Positioning the Printer
2
Basic requirements
The printer will work best if it is installed in a location that is:
❒
Near the computer
If the parallel interface is used to connect the printer to the computer, the connecting cable
should be shielded type and not be longer than 3 meters (10 feet).
❒
Level and well supported
Place the printer on a sturdy table or desk. Do not place the printer on an unstable cart,
stand, or table. The printer may fall, causing injury, or serious damage to the printer.
❒
Near an AC wall outlet, preferably one that can be used for the printer alone (see section
Power Supply
on
next page
).
Power requirements are:
The outlet should be earthed, or an adapter should be used.
If an extension cord is used, the total length of the power cord plus extension should be 5
meters (17 feet) or less.
❒
Well ventilated, not too hot or cold, and not too damp or dry
If you install the printer where the temperature or humidity is outside the above ranges,
you may not get the best print quality, and there will be an increased chance of paper jams.
Voltage
120 V (U.S.A./Canada), 220 to 240 V (European countries),
±10 % at each voltage
Frequency
60 Hz (120 V), ±2 %
50/60 Hz (220 to 240 V), ±2 %
Current capacity
FS-1750: Max. 5.8 A at 120 V, or Max. 3 A at 220 to 240 V
FS-3750: Max. 7.8 A at 120 V, or Max. 4 A at 220 to 240 V
Temperature
10 to 32.5 °C (50 to 90.5 °F)
Humidity
20 to 80 %
Summary of Contents for FS-3750 - B/W Laser Printer
Page 1: ...FS 1750 FS 3750 ...
Page 43: ......
