Performing the Required Operation at the Scanner
25
When performing the scanning operation at your PC
1
Run the TWAIN Source in the corresponding application.
The main dialogue box for the TWAIN Source will appear. Make any settings that you want, and put
a check mark in the [Waiting Scan] checkbox.
Note
Putting a check mark in the [Waiting Scan] checkbox will allow you to start the actual scanning
operation by pressing the
[
Start
]
key at the scanner.
2
Click on the [Connect] button in the main dialogue box and, once the connection to the scanner is
made, click on the [Scan] button.
When the scanner is starting or operating, connection may not be made. In this case, press
[TWAIN] in the Select Scanner Function screen to select the TWAIN mode.
3
Set the original that you want to scan in the scanner
and press the
[
Start
]
key. Scanning will begin.
Notes
•
Scan settings can also be made on the operation panel of the scanner. Change any settings
there that you want.
•
If you enter different values in your computer and in the scanner for the same setting, the
settings made in the scanner will take priority.
Summary of Contents for Scan System (H)
