8 OPTION SETUPS
302 Setting up IP Security Function
2
Select the items below, and then click [OK].
Filter Name
— Enter the filter name.You can enter up to 63 alphanumeric characters and symbols other than #, %,
&, +, ; (semicolon) and , (comma).
Internet Protocol Version
— Selects the IP version for the IP security function.
IPv4
— Select this to use IPsec under the IPv4 environment.
IPv6
— Select this to use IPsec under the IPv6 environment.
Source Address
— The IP address of this equipment is automatically set for this item as a sender address for
communication to which filtering is applied. [My IP Address] is displayed in this box. This item is not changeable.
Destination Address
— Sets a communication address to which the filter is applied.
Specific IP Address
— Sets a specific IP address. Enter the IP address in the address entry box.
Subnet/Prefix
— Sets the destination with its IP address and subnet mask. Enter the IP address and the prefix
of the subnet mask directly in the address entry box.
FQDN
— Sets FQDN for the destination. Enter FQDN in the address entry box.
Any IP Address
— Sets the desired IP address.
Protocol Type
— Selects a protocol to be used for the filter.
Any
— Sets the desired protocol.
TCP
— Select this to use TCP only.
UDP
— Select this to use UDP only.
ICMP
— Select this to use ICMP only.
Source Port
— Sets the port number of the sender. This setting is available only if you selected TCP or UDP in the
protocol type setting.
Any
— Sets the desired source port.
Port Number
— Sets the port number of the sender. Key in the port number in the port number entry box.
Destination Port
— Sets the port number of the destination. This setting is available only if you selected TCP or
UDP in the protocol type setting.
Any
— Sets the desired destination port.
Port Number
— Sets the port number of the destination. Key in the port number in the port number entry box.
Filter Action
— Sets the operation of the filter.
Permit
— Select this to permit access from the specified destination.
Block
— Select this to block access from the specified destination.
Negotiate Security
— IPsec communication is performed with the specified destination. When this item is set,
you must select the security protocol type to be used from the following:
-
ESP
— Select this to use ESP (Encapsulating Security Payload).
-
AH
— Select this to use AH (Authentication Header).
The Add Filter / Modify Filter page is closed and the filter newly created in the list is registered.
The entered content will be deleted when you click [Reset].
Up to 60 filters can be created.
The normal filtering settings are given priority over IP security filtering.
Summary of Contents for TASKalfa 550c
