![background image](http://html1.mh-extra.com/html/kyocera/taskalfa-620/taskalfa-620_service-manual_2015981233.webp)
2KN/2KP
1-5-13
Detaching the separation pulley
13. Remove the separation pulley unit from the
primary paper feed unit.
Figure 1-5-26
14. Remove the bush and stop ring from the
separation pulley unit, and then remove the
separation pulley.
Figure 1-5-27
15. Clean or replace the separation pulley and then
attach the pulley to the separation pulley unit.
* When replacing the separation pulley, make sure
that the projection of the torque limiter fits in the
separation pulley groove.
16. Refit the separation pulley unit to the primary paper
feed unit.
17. Refit the paper feed pulley unit to the primary paper
feed unit.
18. Close the primary paper feed unit and insert the
joint to the paper feed pulley shaft.
19. Refit three stop rings to the primary paper feed unit.
20. Refit the primary paper feed unit.
* When refitting the primary paper feed unit, refit it in
the respective cassette.
Figure 1-5-28
21. When the paper feed pulley, forwarding pulley or
separation pulley is replaced, perform maintenance
mode U901 (clearing copy counts by paper feed
locations) (see page 1-3-87).
Primary paper feed unit
Separation pulley unit
Stop ring
Stop ring
Separation pulley
Bush
Bearing
Projection
Groove
Projection
Summary of Contents for TASKalfa 620
