5
KEW6305
DANGER
● Verify proper operation on a known source before use.
● Verify p
roper operation on a known source before taking action as a result of the indication of
the instrument.
● Never make
measurement on a circuit in which the electrical potential exceeds 600VAC.
● Do not attempt to make measurement in the presence of flammab
le gasses. Otherwise, the use
of the instrument may cause sparking, which can lead to an explosion.
● Never attempt
to use the instrument if its surface or your hand is wet.
- Measurement -
●
Do not exceed the maximum allowable input of any measuring range.
●
Never open the Battery cover during a measurement.
●
Verify proper operation on a known source before use or taking action as a result of indication of
the instrument
- Battery -
●
Do not try to replace batteries during a measurement.
●
Brand and type of the batteries to be used should be harmonized.
- Power cord -
●
Connect the Power cord mains plug to a mains socket outlet.
●
Use only the Power cord supplied with this instrument.
- Power supply connector -
●
Never touch the Power supply connector although it is insulated while the instrument is
operating with batteries.
- Voltage test leads -
● Use only the
ones supplied with this instrument.
● Confirm that the measured voltage rating of the test lead is not exceeded.
●
Do not connect a Voltage test lead unless required for measuring the parameters desired.
● Connect Voltage test leads to the instrument fir
st, and only then connect them to the circuit
under test.
● Never disconnect Voltage test leads while the instrument
is in use.
● Connect to the downstream side of a circuit breaker since a current capacity at the upstream
side is large.
● Do not touch two
lines under test with the metal tips of the test leads.
● Never touch the metal tips of the test leads.
●
Keep your fingers and hands behind the protective fingerguard during measurement.
- Clamp sensor -
● Use only the ones dedicated for this instrument.
● Confirm that the measured
current rating of the test lead is not exceeded.
● Do
not connect a Camp sensor unless required for measuring the parameters desired.
● Connect sensors to the instrument
first, and only then connect them to the circuit under test.
● Never disconnect sensors while the instrument is in use.
● Connect to the do
wnstream side of a circuit breaker since a current capacity at the upstream
side is large.
● Do not touch two lines u
nder test with the metal tips of the test leads.
●
Keep your fingers and hands behind the barrier during measurement.
www.
GlobalTestSupply
.com
Find Quality Products Online at:
sales@GlobalTestSupply.com
