デカール
Decal
2×8
測定位置
40 mm
(60mm)
40 mm
(60mm)
14 mm
(40mm)
14 mm
(40mm)
16 mm
(23mm)
16 mm
(23mm)
ラダー
RUDDER
エレベーター
ELEVATOR
エルロン
AILERON
測定位置
付属のデカールはパッケージ を参考に貼って下さい。
測定位置
図の様に各舵が動くように調整する。図の動作量は通常の飛行に適した舵角です。( )の中は、デュアルレートを使用したアクロ
飛行時の舵角です。
Adjust the travel of each control surface to the values in the diagrams. These values fit general flight capabilities. Into the ( )values fit
acro flight capabilities.
UP
DOWN
10
2mm
の穴をあける(例)。
Drill holes with the specified
diameter (here: 2mm).
2mm
16
デカール
Decal
17
注意して組立てる所。
Pay close attention here!
キャノピー
Canopy
15
2 x 8mm TP
ビス
Screw
6
1.4mm
重心位置
CG
165mm
8mm
Silver Decal
きりはなす
Cut off
銀色デカール
Reference point for
diagram at right.
Reference point for
diagram at right.
Reference point for
diagram at right.
Apply included decals. For the correct placement of
decals, please refer to box top.