36
アイコン解説
注意
ポイント
締め込み注意
方向注意
<{@顎
組み立て順番
^
挟み込み注意
Parts/Units from previous opperation/step
Li‑Po Battery x 3(1‑1)
Serial USB Adaptor x 1(1‑3)
Temporaly assembled Body Flame Unit(2‑2)
CH 1 〜 CH17
Servo Motor(2‑3)
2-4
Setting Nutral Position of Servo Motor
New Prats for this step
[65] Battry Hatch x 1
[112] Serial Extension Cable x 1
［120］Insulating Tape
1
Battry Hatch
2
1.5cm
1.5cm
Process of Setting Nutral Potion of Servo Motor is work of setting Nutral Position = setting basing
point of action from condition of shipment.This process means basing point of assebmling and this will
affect perfprmance of MANOI,so this should be done completely without skipping.
After this process is done, Nutral position ,may be moved by some reason, in that casedo this process
again to set nutral position.
Make sure Power Switch is OFF
Apply Insulating Tape which is cut about 6cm to one of
Li‑Po Battery Pack as photo and view.
Place Tab and line of
underside as straight line
Apply as tab is an extension of Underside of
Battery(side of no MANOI Logo)
If Insulating Tape is cut longer, it will be hard to peel off.
If use longer cut tape, make sure it will not touch
terminal and guide.
When the tape starts losing adhesionr, change to new one.
Household Vynel tape is acceptable for this.
Apply the tape to one battery pack only. If apply to all of
3 battery packs, it may cause situation of Battry Hatch can not get
close‑fitting or hard to remove batteries from body because of too tight.
Summary of Contents for Manoi PF01
