STRATUS Multi-Deck Display Case
25
CAUTION—The following could damage the case:
•
Use of cleaning products containing chlorine, chloride ion, the words Bleach, is not recommended for un-
painted stainless steel surfaces as it may cause rust to form. The operational warranty of the equipment
will be voided if these products cause rust to form on the stainless steel parts or any other parts of the
equipment.
•
Do not use solvent, oil, or acidic-based cleaners on any interior surfaces as the surface may become
damaged.
•
Do not use abrasive cleaners and scouring pads, as these will mar the finish.
• Never introduce water into the case faster than the waste outlet can drain it.
•
Do not use steam or high pressure systems to clean the case, as seals may be broken which will cause the
case to leak.
Shelves
Do not use a hose or submerge shelves in water. When cleaning lighted shelves; wipe down the shelves with a wet
sponge or cloth so that water does not enter the light rails.
Mirrors
Mirrors are sheets of clear glass that have a very thin reflective coating applied to one side. These coatings are sus-
ceptible to deterioration if certain cleaning solutions and even water are allowed to come in contact with them. Every
precaution should be made to keep liquids away from the coated side of the mirrors. If liquids are allowed to flow
along the face side of the mirror to its edge, the liquid can seep between the coating and the glass, causing serious
damage.
To help prolong the life of the mirrors:
•
Use only mild cleaning solutions (Windex, or a weak solution of vinegar and water).
• Do NOT spray liquids on mirrors. Dampen the cleaning cloth, and then use the cloth to wipe the mirror.
•
Wipe water from the mirrors immediately to prevent difficult to remove water spots and also to prevent the
water from reaching the mirrors edge.
• Never use dirty cloths, scrapers, or any other abrasive materials for cleaning.
Honeycomb Assembly
The honeycomb should be cleaned every 6–8 months, de-
pending on store conditions. The honeycomb may be cleaned
with a vacuum cleaner or removed to be washed with soap
and water. The honeycomb must be completely dry before
returning it to the case. Note the position and angle of the
honeycomb when removing from the case. Honeycomb must
be replaced at the same angle.
SCREWS