MANUAL DRIVE SCREEN
Above screen for MANUAL DRIVE.
During AUTO operation, MANUAL DRIVE screen can not be opened.
- WELDING COUNT : Total number of welded points for making one cage completely.
- DRUM COUNT : Total number of DRUM r.p.m. for making one cage completely.
- TRANSFER ENCODER : Present value of TRANSFER ENCODER..
- POLE ENCODER : Present value of POLE ENCODER.
- DRUM Hz, BELL Hz, TRANSFER Hz, POLE Hz의 FREQUENCY Hz: Shows present Hz.
- MANUAL SETTING : Hz for each part can be set up for MANUAL DRIVE.
※ Note: This Hz setting value is working at MANUAL DRIVE only, and it is
not effect to AUTO drive screen.
- MANUAL DRIVE: All button in MANUAL DRIVE is working as loong as pushed as same
function of buttons on MAIN PANEL.
- Each part Yellow color bar change to Red color bar at time of stop by Proximity Switch.
- TRANSFER REAL DATA, POLE REAL DATA means actual value of ENCODER in distance (mm).
- Operation fail in value "0", tap this bar to operate MANUAL DRIVE.
Summary of Contents for KN-1248-G3
