6. Input Barrel Pitch.
- Input digit more than 30.
- Drum r.p.m. is fixed between Barrel Length and Transfer is moving as per pitch.
7. Input Barrel Size.
- Insert 2 longitudinal wire in wire die with enough length to measure diameter.
- Measures distance between outside and outside of wire by a tap, and input digit.
8. As per following drawing, moves Bell Reduce Stop Proximity Switch(#3) inside until
red lamp light and fix screw tight.
A-PIPE is not effected by #1 and #2 P/X switch.
9. As per above drawing, moves POLE F/W, B/W to makes gap(A) 4~5mm.
- Input digit on Pole Position green bar(Left) same digit as dark green(Right)
※ If Encoder NO USE is selected from MANUAL SCREEN, moves Proximity Switch(#6)
inside and fixed screw.
10. Check Bell, Transfer, Pole bar of Return Complete became green color.
※ If any one bar of them in not green color, START ERROR will be happened.
11. Push WIRE DRUM ON button and adjust Wire Guide Holder (#4 & #5) for round spiral wire.
12. Push DRUM ROTATING button to be positioned at Welding Point(#B).
13. Push CYLINDER button to close Cylinder to contact spiral wire to longitudinal wire.
14. Adjust air pressure of #7 and #8.
- Air pressure should be adjusted according to longitudinal and spiral wire diameter.
Example: 5mm Longitudinal wire x 6mm Spiral wire
#7 Air pressure = 5 bar #8 Air pressure = 3 bar
15. Tuning SLOW Welding Volume on Main Panel at 8.0 in case wire condition same as 14.
- Push RESET button and tuning Fast Welding Volume more than 8.0 (9.0 or 10.0).
- Makes Welding current 0~30.
- Tuning WELDING TIME Volum at 6.0
- 6.0 means 6.0 m/s welding time of 1 point which should be changed as per Drum r.p.m.
- Welding Time is 0~65m Second. Longer welding time is helpful for good welding, but
jump up one welding point which makes no welding for next point. Set up short time
and slowly longer time after checking out welding condition.
16. Set up Drum r.p.m.
- Drum r.p.m. should be adjust according to Pipe diameter.
- Set up 6000 for 12"~33" Pipe, 5000 = 36~42" 4000 = 48"
1
2 3
A
4
5
6
7 8
B
Summary of Contents for KN-1248-G3
