8
3.
Then connect the hotbed heating wire and thermistor wire, like in picture 3.
4.
Install two-foot levelling pats as shown in picture 4, and adjust the height of the
foot levelling pats to make the printer stable or to the height that you need.
3
4
5.
As shown in picture 5, fix the filament holder on the top profile, then tighten the
T-rod nuts of the holder.
5
Install the tempered Glass platform and Connect the power Cord
1.
As shown in picture 1a and picture 1b, place the glass on the silver-white
platform and clamp it with the binder clips. Be careful not to clamp the hotbed
cable.
