SKY899
Installation Manual
009-11900-001
Appendix F - Page F-5
Revision F
July 18, 2013
5.
From the Setup menu, select Audio Level (3 <Enter>):
a.
Test the audio level by selecting Test (3 <Enter>). Verify the aural “Traffic, Traffic” message is
heard at a comfortable level (adjust level per step b below).
b.
Set the desired audio level using the Up (1 <Enter>) and Down (2 <Enter>) selections (level is
adjusted in 5% increments).
c.
Select Back (x<Enter>) to return to setup menu.
Audio Level
Volume
[50%]
1 Up
2 Down
3 Test
x Back
Choice:
6.
From the Setup menu, select ARINC 429 ports (4 <Enter>).
NOTES
1.
It is possible for multiple data inputs (barometric altimeter, radio altimeter,
magnetic heading and GPS navigation) from one source to be received on one
channel (e.g., ARINC-429 superbus). Multiple data inputs will be indicated by
the word Multi in the ARINC 429 Receiver Menu.
2.
The data rate for receive channels 1 and 2 must be set to the same speed (12.5
or 100 kHz). The data rate for receive channels 3 and 4 must be set to the
same speed (12.5 or 100 kHz). The data rate for channel 5 is independent of
the other receivers. Channel 5 can be set to 12.5 or 100 kHz.
3.
Autodetect will configure the equipment type and speed of each receiver
channel. To identify the equipment Autodetect checks for ARINC-429 label
377 (equipment ID), if that's not present then it checks for label 371 (general
aviation equipment ID). If the equipment can not be identified then the
receiver channel will be set to the default of NoType and NoSpeed.
Autodetect will not work for multiple data inputs (i.e., ARINC-429 superbus),
in that circumstance receiver channel and speed must be set individually.
7.
To setup ARINC 429 using Autodetect, select Autodetect (0<Enter>):
The document reference is online, please check the correspondence between the online documentation and the printed version.
